Universal MCU & Memory Programmer

Your Device,
Your Rules.

The world's first user-defined programmer. One tool to read, write, clone and repair the microcontrollers and memory chips inside modern vehicles.

Order on WhatsApp See supported chips
  • Power
  • Busy
  • UART
  • ISP

What it is

One bench tool for MCUs and memory chips

HULKPROG is a professional universal programmer built for automotive electronics, ECU and module repair, and bench-level chip work. In a single tool it reads, writes, clones and repairs microcontrollers and memory chips — EEPROM, Flash and serial memories — across dozens of families from every major silicon manufacturer.

Where most tools lock you into a fixed device list, HULKPROG is user-defined: you choose the target, the interface and the workflow. Read a donor, write a replacement, virginize a module, or recover a bricked chip.

Top-down view of the HULKPROG programmer

Hardware

Built for real bench work

  • Universal ZIF socket

    Drop-in programming for DIL-packaged chips — no soldering required.

  • ISP / ICSP header

    Colour-coded in-system pins to read & write chips on the board, without desoldering.

  • UART interface

    Serial communication for boot-mode and single-wire programming protocols.

  • Status indicators

    Dedicated POWER, BUSY, UART and ISP LEDs for clear, real-time feedback.

  • USB connection

    Plug-and-play link to the PC software, self-powered for stable operation.

  • Adapter-ready

    Optional socket adapters for SOIC, TSOP, QFP and BGA packages.

ISP and ICSP/UART headers with colour-coded pinout
Colour-coded ISP / ICSP / UART headers
Front I/O: USB Type-C, DB-25 and power input
USB · DB-25 · DC power
Rear I/O panel of the HULKPROG
Rugged, shielded housing

What it does

Core programming functions

Everything a read/write job needs, on one board.

  • Read / DumpFull backup of Flash, EEPROM and configuration areas
  • Write / ProgramFlash new firmware or calibration data
  • VerifyBit-perfect confirmation after writing
  • EraseFull or sector erase
  • Blank CheckConfirm a chip is empty before writing
  • Auto Chip IDAutomatic detection of the connected device
  • ChecksumIntegrity validation of the data
  • Config / Fuse bitsRead and edit protection & configuration registers
  • OTP supportOne-time-programmable device handling
  • ISP on-boardDump and program without removing the chip

On the job

Purpose-built for the modern workshop

HULKPROG on a workshop bench with a vehicle under repair
  • ECU & TCU bench work — read and write P-Flash / D-Flash on engine and transmission control units (PowerPC, TriCore, Renesas).
  • Immobilizer & security modules — read/write EEPROM on immo, BCM and KVM units.
  • Module cloning & replacement — read a donor module, write a matched replacement.
  • Virgin file writing — flash clean/virgin data to a replacement BCM/KVM.
  • Instrument cluster repair — read and restore EEPROM after a dashboard swap.
  • Bricked chip recovery — rebuild a damaged memory from a good dump.
  • Tuning file access — read and write Flash for calibration and remapping.
HULKPROG programmer with a vehicle behind it — ECU/TCU/MCU, IMMO, BCM/KVM, cluster, tuning and bricked-chip recovery

Coverage

Supported devices

A cross-manufacturer library of MCUs and memories — and it keeps growing. Key families highlighted.

Atmel

9
  • AT24
  • AT90
  • AT91SAM7 · ARM7
  • AT91SAM9 · ARM9
  • AT91SAM D/4C · Cortex
  • AT93
  • AVR XMEGA
  • megaAVR
  • tinyAVR

Infineon

4
  • XC166
  • XE16x
  • XC2000
  • TriCore

NXP · Freescale

10
  • LPC11/13/17/18 · Cortex
  • LPC2000 · ARM7
  • PCF8563 RTC
  • HC08
  • MCF51 · Coldfire
  • MPC55/56 · PowerPC
  • S08
  • S12 / S12X / S12Z
  • Kinetis MKL · Cortex

Renesas

9
  • 78K0/0R/0S
  • H8 / H8S / H8SX
  • M16C / M32C
  • R32C / R8C
  • RH850
  • RL78
  • RX
  • SH
  • V850

STMicroelectronics

9
  • M24/25/45/93/95
  • M41T RTC
  • SPC56 · PowerPC
  • ST7
  • ST30 · ARM7
  • STA · ARM7
  • STM8
  • STM32 · Cortex
  • UPSD3x

Microchip

4
  • 24 / 93 Memories
  • dsPIC33
  • PIC10/12/16/18/32
  • SST25 Serial Flash

Texas Instruments

4
  • CC25
  • MSP430
  • TMS320F
  • TMS570LS

Micron · Numonyx

4
  • M25
  • M29
  • M45
  • N25Q

Spansion

2
  • S25
  • S29

GigaDevice

1
  • GD25 Serial Flash

Fujitsu

3
  • MB95
  • MB96
  • MB9D FCR4 · Cortex

Seiko · SII

3
  • S-24
  • S-25
  • S-93

EON

1
  • Serial Flash memories
HULKPROG box, carry case, cable set and power adapter

Why HULKPROG

Your device, your rules

  • One tool, thousands of chips — memories and MCUs from Atmel, NXP, Renesas, ST, Infineon, TI, Microchip and more.
  • In-socket and on-board — ZIF for loose chips, ISP for chips still on the PCB.
  • Built for the bench — fast, stable and clear, with real-time status feedback.
  • User-defined — you decide the target, the interface and the workflow.

Get in touch

Questions, pricing or shipping?

Message us on WhatsApp and get a real answer — usually within a few hours, workshop time. Supplied and supported by Diatronik.

+33 7 68 86 29 98

Chat